2009 Nissan Versa Owner's Manual - Page 101

Auto-reverse function The auto-reverse function can be activated when a window is closed by automatic operation. Depending on the environment or driving conditions, the auto-reverse function may be activated if an impact or load similar to something being caught in the window occurs. When power window switch does not operate If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system. 1. Place the ignition switch in the ON position. 2. Open the window more than halfway by operating the power window switch. 3. Pull up and hold the window switch and hold it to close the window, and then hold the switch for more than 3 seconds after the window is closed completely. 4. Release the power window switch. Operate the window by automatic function to confirm the initialization is complete. 5. Perform steps 2 through 4 above for other windows. If the power window automatic function does not operate properly after performing the above procedure, see a NISSAN dealer for assistance. WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window. If the vehicle's battery is disconnected, replaced, or jump started, the power window auto-reverse function may not operate properly. If this occurs, please contact a NISSAN dealer to re-initialize the power window auto-reverse system. If the control unit detects something caught in a window equipped with automatic operation as it is closing, the window will be immediately lowered. WIC0263 MANUAL WINDOWS (if so equipped) The side windows can be opened or closed by turning the hand crank on each door. Instruments and controls 2-31