2011 Nissan Rogue Owner's Manual - Page 50

manufacturer's instructions to remove any slack. If you have any questions when installing a top tether strap, consult your NISSAN dealer for details. BOOSTER SEATS Precautions on booster seats WARNING SSS0803 Forward-facing - step 10 SSS0802 10. If the child restraint is installed in the front passenger seat, place the ignition switch in the ON position. The front passenger air bag should illuminate. If this status light light is not illuminated, see "Front passenger air bag and status light" in this section. Move the child restraint to another seating position. Have the system checked by a NISSAN dealer. After the child restraint is removed and the seat belt is fully retracted, the ALR mode (child restraint mode) is canceled. INSTALLING TOP TETHER STRAP First secure the child restraint with the LATCH system (rear outboard seating positions only) or the seat belt as applicable. 1. Remove the anchor cover from the anchor point which is located directly behind the child seat. 2. Position the top tether strap over the top of the seatback. 3. Secure the tether strap to the tether anchor bracket that provides the straightest installation. 4. Tighten the tether strap according to the If a booster seat and seat belt are not used properly, the risk of a child being injured in a sudden stop or collision greatly increases: - Make sure the shoulder portion of the belt is away from the child's face and neck and the lap portion of the belt does not cross the stomach. - Make sure the shoulder belt is not behind the child or under the child's arm. - A booster seat must only be installed in a seating position that has a lap/shoulder belt. 1-34 Safety - Seats, seat belts and supplemental restraint system