2014 Nissan Rogue Owner's Manual - Page 143
2014 Nissan Rogue Manual
Page 143 highlights
PROGRAMMING HOMELINK® If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or call 1-800-355-3515. NOTE: Place the ignition switch in the ACC position (if so equipped) when programming HomeLink®. It is also recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink® for quicker programming and accurate transmission of the radio-frequency. 1. Position the end of your hand-held transmitter 1-3 in (2-8 cm) away from the HomeLink® surface, keeping the 1 in view. HomeLink® indicator light ᭺ LIC2365 LIC2366 2. Using both hands, simultaneously press and hold the desired HomeLink® button and hand-held transmitter button. DO NOT re1 lease until the HomeLink® indicator light ᭺ flashes slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. (The rapid flashing indicates successful programming.) NOTE: Some devices may require you to replace Step 2 with the cycling procedure noted in "Programming HomeLink® for Canadian customers and gate openers" in this section. 3. Press and hold the programmed HomeLink® button and observe the indicator light. 1 is ● If the indicator light ᭺ solid/continuous, programming is complete and your device should activate when the HomeLink® button is pressed and released. 1 blinks rapidly for ● If the indicator light ᭺ two seconds and then turns to a solid/continuous light, continue with Steps 4-6 for a rolling code device. A second person may make the following steps easier. Use a ladder or other device. 2-58 Instruments and controls