2003 Oldsmobile Silhouette Owner's Manual - Page 156

Before your vehicle was shipped from the factory, it was programmed in Mode 1. The mode to which the vehicle was programmed may have been changed since it left the factory. To determine the mode to which your vehicle is programmed or to program your vehicle to a different mode, do the following: 1. Follow the instructions for Entering Programming Mode on page 2-63. 2. Insert your spare key fully into any door key cylinder and turn it to the unlock position. This step is necessary to prevent accidental programming of this feature to Mode 2. Do not program this feature to Mode 2 without first reading Mode 2 entirely. The door key cylinder must remain in the unlock position during Steps 2 through 4. 3. Press the button with the horn symbol on the remote keyless entry transmitter. 5. Press the panic button to change the current mode. 6. Press the panic button until you hear the number of chimes corresponding to the mode selection you want. 7. Remove your key from the door key cylinder. The mode you selected is now set. You can either exit the programming mode by following the instructions next in this section or program the next feature available on your vehicle. Exiting Programming Mode To exit programming mode, turn the key from ACCESSORY to OFF and put the BCM PRGRM fuse back into the instrument panel fuse block. After programming a feature, you can exit the programming mode at anytime. Also, if your vehicle is equipped with the content theft-deterrent system, remember to arm the svstem before exitinq. 4. Count the number of chimes you hear. The number of chimes indicates the vehicle's curreni programmed mode. (ii you ao not wish io change the current mode, you can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle.) 2-71