2006 Polaris FST Touring Owners Manual - Page 47
2006 Polaris FST Touring Manual
Page 47 highlights
FEATURES Instrumentation MFD Battery Replacement If the clock function of the MFD isn't A working properly, replace the battery. Replacement batteries are available from your dealer. 1. Remove the plenum from the underside of the hood. 2. Locate the black battery B compartment (A). It has a red wire and a brown wire with a white stripe. It's located about three inches down the main harness from the point where the harness connects to the MFD. 3. Cut the plastic cable tie (B) from C the outside of the compartment. 4. Carefully cut the bottom of the compartment (opposite the wires) to separate the heat-sealed seams. Squeeze the corners of the compartment inward so the battery (C) is visible. NOTE: Note the orientation of the battery before removing it. An incorrectly installed battery will not maintain the clock. 5. Using needle-nose pliers, grasp the battery and rotate it slightly so the leading edge of the battery is raised slightly away from the battery holder. Pull the battery out gently. NOTE: The battery will not come out of the holder unless the leading edge of the battery is raised. Hold the battery compartment, not the wires, while removing the battery. Pulling on the wires will separate them from the battery holder. 44