2008 Polaris Ranger Crew Owners Manual - Page 97
2008 Polaris Ranger Crew Manual
Page 97 highlights
MAINTENANCE Lights Headlight Beam Adjustment X 25 ft. (7.6 m) X 8" (20 cm) 1. Place the vehicle on a level surface with the headlight approximately 25 ft. (7.6 m) from a wall. 2. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height. 3. Apply the brakes. Start the engine. Turn on the headlights. 4. Observe the headlight aim. The most intense part of the headlight beam should be aimed 8" (20 cm) below the mark placed on the wall in step 2. NOTE: Include the weight of a rider on the seat while performing this step. 5. If the headlight needs adjustment, open the hood. NOTE: The lights are part of the hood assembly. 6. Turn the adjustment screw to adjust the beam. 7. Close the hood. Repeat steps 4-6 until the beam is properly adjusted. Adjustment Screw View of driver's headlight with hood lifted. Brake Lights When the brake pedal is depressed, the console brake light comes on. Check the brake light before each ride. 1. Turn the ignition switch to the ON position. 2. Depress the brake pedal. The brake light should come on after about 10 mm (0.4 in.) of pedal travel. If the light doesn't come on, check the bulb. 94