2009 Polaris Ranger 700 4x4 EFI Owners Manual - Page 63
2009 Polaris Ranger 700 4x4 EFI Manual
Page 63 highlights
OPERATION All Wheel Drive (AWD) The illuminated amber AWD switch indicates that the vehicle is in AWD. When the AWD switch is on, the front wheels will automatically engage any time the rear wheels lose traction. When the rear wheels regain traction, the front wheels will automatically disengage. There is no limit to the length of time the vehicle may remain in AWD. Initially, the vehicle's electronic system will not enable the AWD until the engine RPM is below 3100. Once enabled, the AWD remains enabled until the AWD switch is turned off. If the switch is turned off while the front gearcase is moving, it will not disengage until the rear wheels regain traction. Engage the AWD before getting into conditions where front wheel drive may be needed. If the rear wheels are spinning, release the throttle before switching to AWD. NOTICE Switching to AWD while the rear wheels are spinning may cause severe drive shaft and clutch damage. Always switch to AWD while the rear wheels have traction or are at rest. Disengaging AWD Under certain conditions, it may be possible for the front gearcase to remain locked unnecessarily. This condition causes increased steering effort and some vehicle speed restriction. If the front gearcase remains locked after following these instructions, return the vehicle to your dealer for service. 1. Stop the vehicle. 2. Operate in reverse for at least 10 feet. 3. Stop completely. 4. Shift into low gear and drive forward. 60