2013 Polaris Cross Country Owners Manual - Page 22
2013 Polaris Cross Country Manual
Page 22 highlights
Instruments, Features and Controls Instrument Cluster (CROSS ROADS) Speedometer The speedometer displays vehicle speed in either miles per hour (MPH) or kilometers per hour (km/h). Speedometer Indicator Lamps Multi-Function Display Indicator Lamps Lamp Indicates Neutral High Beam Turn Signal Condition This lamp illuminates when the transmission is in neutral and the ignition key is in the ON position. This lamp illuminates when the headlamp switch is set to high beam. The turn signal indicator flashes when the left, right, or both turn signals (hazard) are active. If a bulb fails, or if there is a short circuit in the signal system, the lamp flashes at more than twice the normal rate. This lamp illuminates when approximately one gallon (3.8 liters) of fuel remains in the fuel tank. Before using the cruise control (if equipped), read the safety and operation procedures beginning on page 51. This lamp illuminates momentarily when the ignition switch is in the ON position and the engine is off. This indicates proper function. This lamp will illuminate if the engine is disabled by the sidestand interlock switch. See page 34. The light will also remain on if the tilt sensor shuts down the engine. See page 34. If this lamp illuminates while the engine is running, contact an authorized VICTORY dealer promptly for diagnosis. If abnormal sensor or engine operation is detected the light will remain on as long as the fault condition exists. Retrieve the error codes for diagnosis. See page 26. The ABS indicator always illuminates when the key is in the ON position and remains on until the anti-lock system activates, which occurs when vehicle speed exceeds 6 MPH (10 km/h). When the lamp is illuminated, the anti-lock brakes will not activate, but the conventional brake system will continue to operate normally. Low Fuel Cruise Control Engaged Check Engine Anti-Lock Brake System Not Activated (if equipped) 20