2009 Suzuki SX4 Owner's Manual - Page 217

Tires: 6 INSPECTION AND MAINTENANCE Tire Size The following illustration shows an example of a typical passenger car tire size. the type of ply construction in the tire. The letter "R" means radial ply tire construction, the letter "D" means diagonal or bias ply construction, and the letter "B" means belted-bias ply construction. E. Rim Diameter This two-digit number is the wheel or rim diameter in inches. WARNING A B C D E Tire Inflation Pressure Tire inflation pressure should be checked when the tire is cold. "Cold tire inflation pressure" is the pressure in a tire that has been driven less than 1 mile (1.6 km) or has been standing for three hours or more. 67D028 A. Tire Type This letter code indicates the primary intended use of the tire. The letter "P" identifies a tire primarily intended for use on a passenger vehicle. B. Tire Width This three-digit number indicates the tire section width in millimeters from sidewall to sidewall. C. Aspect Ratio This two-digit number represents the tire section height divided by the tire section width. D. Construction Code This letter code is used to indicate Your SUZUKI is equipped with tires which are all the same type and size. This is important to ensure proper steering and handling of the vehicle. Never mix tires of different size or type on the four wheels of your vehicle. Mixing tires could cause you to lose control while driving which may lead to an accident. The size and type of tires used should be only those approved by SUZUKI Motor Corporation as standard or optional equipment for your vehicle. 80JS025 The front and rear tire pressure specifications for your vehicle are shown below and are listed on the Tire and Loading Information Label, which is located on the driver's door lock pillar. The Tire and Loading Information Label contains the following information: • Seating Capacity • Maximum Allowed Combined Weight of Occupants and Cargo • Original Tire Size 9-26 80J22-03E