2009 Volvo S40 Owner's Manual - Page 223
2009 Volvo S40 Manual
Page 223 highlights
09 Maintenance and servicing Replacing bulbs Introduction Before replacing bulbs in your vehicle, please keep the following points in mind: 09 Removing the headlight housing WARNING light, turn signal, and side marker bulbs. To lift out the housing: 1. Remove the key from the ignition and turn the headlight switch to position 0. 2. Open the hood. 3. Pull up the headlight housing's retaining pin. 4. Pull out the headlight housing. NOTE Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the heat and will leave a deposit on the reflector, which will damage it. The optional Bi-Xenon headlight bulbs contain trace amounts of mercury. These bulbs should always be disposed of by a trained and qualified Volvo service technician. Certain bulbs should only be replaced by a trained and qualified Volvo service technician: • • The engine should not be running when changing bulbs. When changing in the headlight housing, if the engine has been running just prior to replacing bulbs, please be aware that components in the engine compartment will be hot. • • Brake lights Bi-Xenon headlights, Brake lights G019599 The entire headlight housing must be lifted out when replacing the high/low beam, parking 5. Disconnect the wiring connector by pressing down the clip with your thumb while at the same time pulling the connector with your other hand. G019600 Courtesylighting Reading lights Glove compartment lights Turn signals and courtesy lights in the side door mirrors 223