2009 Volvo S40 Owner's Manual - Page 224

09 Maintenance and servicing 09 Replacing bulbs 6. Lift out the headlight housing and place it on a soft surface to avoid scratching the lens. Low beam bulb CAUTION When disconnecting the connector, pull on the connector itself and not on the wiring. After the defective bulb has been replaced, reinsert the housing in the reverse order. Check that the retaining pin is correctly inserted. WARNING Bi-Xenon headlights (option) - due to the high voltage used by these headlights, these bulbs should only be replaced by a trained and qualified Volvo service technician. Cover with retaining clamps G019131 Low beam bulb Installing a new bulb 1. Insert the new bulb. It can only be installed in one position. 2. Press the retaining spring inward and upward and slightly to the right until it snaps into place. 3. Press the wiring connector onto the bulb. 4. Put the plastic cover in place. 5. Press the retaining clamps back into place. 6. Reinstall the headlight housing (see page 223). 1. Open the hood and remove the headlight housing (see page 223 for instructions). 2. Release the retaining clamps on the cover. 3. Release the bulb's retaining spring holding the bulb in place by pressing it inward and downward. 4. Pull out the bulb. 224 G019133