2011 Volvo S60 Owner's Manual - Page 295
2011 Volvo S60 Manual
Page 295 highlights
08 Maintenance and specifications Replacing bulbs Removing the headlight housing 1. Switch off the ignition by briefly pressing the START/STOP ENGINE button and remove the remote key from the ignition slot1. 2. (Upper illustration under "Headlight housing") Withdraw the headlight housing's locking pins. Remove the headlight housing by alternatively pulling the front and rear edges until it can be lifted out. 5. Replace the defective bulb(s). Reinserting the headlight housing Removing the cover to access the bulbs CAUTION When disconnecting the connector, pull on the connector itself and not on the wiring. 1. Plug in the connector until it clicks into place. 2. Reinstall the headlight housing and locking pins. The short locking pin should be closest to the grille. Check that they are correctly inserted. The headlight housing must be properly inserted and secured in place before the lighting is switched on or the remote key is inserted into the ignition slot. 3. Check that the lights function properly. NOTE Before starting to replace a bulb, see page 294. 3. (Lower illustration under "Headlight housing") Unplug the wiring connector by holding down the clip with your thumb. Pull out the connector with the other hand. 4. Lift out the housing and place it on a soft surface to avoid scratching the lens. 1. Loosen the cover's four retaining screws with the tool (1) provided in the vehicle's tool kit (see page 278). The screws should not be removed completely. 08 1 Does not apply to vehicles with the optional keyless drive. `` 295