2011 Yamaha Motorsports RS Venture GT Owners Manual - Page 95
2011 Yamaha Motorsports RS Venture GT Manual
Page 95 highlights
Periodic maintenance and adjustment RS90GT / RS90LTGT / RST90GT 6. 2 7. Remove the V-belt from the secondary sheave assembly and primary sheave assembly. Temporarily install the new V-belt on the secondary sheave assembly only, and then measure the V-belt position. Do not force the V-belt between the sheaves; the secondary sliding and fixed sheaves must touch each other. 1 1. Screw 2. Left lower cover 4. Rotate the secondary sliding sheave clockwise and push it so that it separates from the secondary fixed sheave. 2 1 1. Secondary sliding sheave 2. Secondary fixed sheave 5. Pull the V-belt up over the secondary fixed sheave. 1. Edge of the secondary sheave assembly 2. Standard V-belt position Standard V-belt position: From 1.5 mm (0.06 in) above the edge of the secondary sheave assembly to 0.5 mm (0.02 in) below the edge 8. If the V-belt position is incorrect, adjust it by removing or adding a spacer on each V-belt position adjusting bolt. 1. V-belt 89