3Com 3C905-TX Installation Guide - Page 14

CAUTION HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide Software Installation Procedure Installing the Driver from the Hard Disk (Advanced Users) To install the network driver in a PC running Windows NT version 4.0 from driver files on the hard disk: 1 Restart the PC and start Windows NT. 2 Create a folder for the drivers, for example, C:\LAN3COM. 3 Insert EtherDisk® diskette #1 in your drive and copy the entire contents to your new folder. 4 Insert EtherDisk® diskette #2 in your drive and copy the entire contents to your new folder. If you are prompted to overwrite any files click on Yes. 5 Perform the installation from step 2 onwards of "Installing the Driver from the EtherDisk® diskettes" on page 12. At step 8, specify the folder that you copied the files to, for example, C:\LAN3COM\WINNT. Updating the Driver If you already have the 3C905B-TX network driver and want to update it, follow the instructions provided below. 1 Double-click on the My Computer icon, then double-click on the Control Panel icon. 2 In the Control Panel window, double-click on Network. 3 In the Network window, click on the Adapter tab. 4 Highlight 3Com Fast EtherLink XL NIC (3C905B-TX) and click on Update. 5 Insert EtherDisk® diskette #1 in your drive and type A:\ at the prompt, then press ENTER. The driver will be automatically updated. 6 Close the Network window and restart the computer when prompted. If a service pack was already installed on the PC before the network interface card was installed, the service pack must be reinstalled. This will overcome the At Least One Service Failed to Start error when Windows NT is started. On some platforms you also need to reinstall certain drivers after installing the Service Pack. Refer to your PC documentation for more information. 14 English