3Com 3C905-TX Installation Guide - Page 18

NOTE HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide HP Support Services The PC Cannot Be Started or Woken-Upfrom the Network 1 If the PC has been powered off (for example, due to an electrical power failure, or because the power cord has been removed), the Remote Power On (RPO) will not work. To enable the RPO, you must first power on the PC, allow the Operating System to boot, then shut down the PC. 2 Check that the WOL connector cable is connected to the network interface card and to the PC's system board. 3 Check that the LAN-specific fields in the HP PC Setup utility are correctly set (refer to refer to "Updating LAN-specific Fields in the HP PC Setup Utility" on page 9.) RPO is only supported under Windows 95, Windows 98 and Windows NT 4.0. HP Support Services The latest drivers and utilities are available on HP's Web site at: For HP Vectra PCs For HP Brio PCs For HP Kayak PC Workstations www.hp.com/go/vectrasupport www.hp.com/go/briosupport www.hp.com/go/kayaksupport 18 English