3M DB565 Safety Guide - Page 4

Warning, Caution - manual

Page 4 highlights

Introduction 3M™ Digital Board  WARNING To reduce the risk associated with the various hazards related to the 3M Digital Board: • Please read, understand and follow all safety information contained in this installation manual prior to the installation and use. To reduce the risk associated with impact: • Always provide proper adult supervision when using the 3M Digital Board around children. • Always place the 3M Digital Board on a stable and level surface. • Install the 3M Digital Board on a wall with 1/2-inch-thick drywall minimum. • Use only 3M recommended wall mounting hardware. • Follow all installation instructions carefully. • Make sure mounting screws are properly sized to handle the weight of the 3M Digital Board. • Make sure mounting hardware is securely anchored to a solid structure. • Proper installation must be performed by qualified service technicians, as outlined in the installation instructions. Failure to do so could result in serious injury and/or damage to the 3M Digital Board. • At least two qualified service technicians should perform the installation procedure. Serious personal injury and/or damage can result from dropping the 3M Digital Board To reduce the risk associated with choking: • Keep batteries away from children and pets.  CAUTION To reduce the risk associated with environmental contamination: • Dispose of 3M™ Digital Board components in accordance with applicable federal, state, and local regulations. To reduce the risk associated with chemical leakage, hot battery surface and battery rupture: • Use only same type AA alkaline batteries in presentation pen. • Avoid fire and heat sources above 100 C. • Do not short circuit batteries. • Do not attempt to recharge batteries. • Do not break or disassemble batteries. • Avoid eye and skin contact, ingestion and inhalation of battery chemicals in the event of a ruptured or broken battery. • Replace all batteries at same time. • Properly orient the plus (+) and minus (-) terminals of batteries. • Remove batteries when not used for an extended period of time. 4 © 3M 2005. All Rights Reserved.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

4
Introduction
3M™ Digital Board
© 3M 2005. All Rights Reserved.
WARNING
To reduce the risk associated with the various hazards related to the 3M Digital Board:
Please read, understand and follow all safety information contained in this installation manual prior to the
installation and use.
To reduce the risk associated with impact:
Always provide proper adult supervision when using the 3M Digital Board around children.
• Always place the 3M Digital Board on a stable and level surface.
• Install the 3M Digital Board on a wall with 1/2-inch-thick drywall minimum.
• Use only 3M recommended wall mounting hardware.
• Follow all installation instructions carefully.
• Make sure mounting screws are properly sized to handle the weight of the 3M Digital Board.
• Make sure mounting hardware is securely anchored to a solid structure.
Proper installation must be performed by qualified service technicians, as outlined in the installation
instructions. Failure to do so could result in serious injury and/or damage to the 3M Digital Board.
At least two qualified service technicians should perform the installation procedure. Serious personal injury
and/or damage can result from dropping the 3M Digital Board
To reduce the risk associated with choking:
• Keep batteries away from children and pets.
CAUTION
To reduce the risk associated with environmental contamination:
Dispose of 3M™ Digital Board components in accordance with applicable federal, state, and local
regulations.
To reduce the risk associated with chemical leakage, hot battery surface and battery rupture:
• Use only same type AA alkaline batteries in presentation pen.
• Avoid fire and heat sources above 100 C.
• Do not short circuit batteries.
• Do not attempt to recharge batteries.
• Do not break or disassemble batteries.
Avoid eye and skin contact, ingestion and inhalation of battery chemicals in the event of a ruptured or broken
battery.
• Replace all batteries at same time.
• Properly orient the plus (+) and minus (-) terminals of batteries.
• Remove batteries when not used for an extended period of time.