3Ware 7506-12 User Guide - Page 34
Install the Drives, Check your installation and close the case, Check motherboard boot sequence - sata raid
UPC - 693494756128
View all 3Ware 7506-12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
3ware Hardware Installation If you are using a standard enclosure, connect each of the individual SATA connectors to a drive. Install the Drives 1 If your drives are not already installed, install them now, either by attaching them to the backplane, or by installing them in the computer chassis. 2 Be sure that the power supply is connected to either the backplane or the individual drives. Check your installation and close the case 1 After all of the drives are connected to the ATA RAID Controller and it is installed in its slot, verify that the cables do not interfere with the operation of any other components in the case or block the flow of cooling air. 2 Close the case and reconnect the power cables. Check motherboard boot sequence Using your computer's Setup utility, ensure that your boot device precedes the Escalade ATA RAID Controller in the boot sequence. If you have other disks installed on the motherboard, the ATA RAID Controller precedes them in boot order. 26 3ware Escalade ATA RAID Controller User Guide