3Ware 7506-12 User Guide - Page 83
RAID array initialization, Materials required, The driver file is named - sys
UPC - 693494756128
View all 3Ware 7506-12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
6 Copy the Makefile to /sys/modules/twe. 7 Rebuild the kernel. (Refer to the FreeBSD documentation for how to rebuild the kernel.) 8 Install the new kernel 9 Reboot with the new kernel. RAID array initialization RAID 0 arrays do not need to be initialized and are immediately available for use with full performance when created. RAID 1 and 10 arrays are not initialized when created and are immediately available for use with full performance when created. The first time the array is verified (via the BIOS or 3ware 3DM), the array is initialized. Initialization results in data from one disk (the disk on the lower channel number) being copied to the other drive. In RAID 10 arrays, data from one half of the array is copied to the other half. After the initial verification, subsequent verifies to a RAID 1 or 10 array result in the data from one drive (or set of drives) being compared to the other drive (or set of drives). RAID 5 arrays are immediately initialized after being created in the BIOS by writing zeroes to all array members. The user can reboot the system before this is complete in order to use the RAID 5 array immediately. Once booted to the operating system, the RAID 5 array goes into initialization mode after a delay of up to ten minutes. The advantage of this procedure is that the RAID 5 array can be used immediately, but it will not be fault tolerant until the initialization is complete. The disadvantage of this is that it takes longer for the array to become fully redundant, because it takes longer to initialize an array than it does to write zeroes to the array. Installing the ATA RAID controller on systems that boot from a different device Materials required: ■ 3ware Escalade driver. Check your 3ware CD-ROM for a FreeBSD folder. If you do not find one, download the FreeBSD driver from the 3ware web site (http://www.3ware.com). The driver file is named twe.ko. www.3ware.com 75