AEG AGN71800C0 Product Manual - Page 12
Closing the door - installation manual
View all AEG AGN71800C0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 www.aeg.com Problem Possible cause Solution The compressor does not start immediately after pressing the FROSTMATIC, or after changing the temperature. This is normal, no error has The compressor starts after a occurred. period of time. Water flows on the floor. The melting water outlet is not connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray. Temperature cannot be set. The FROSTMATIC or COOLMATIC function is switched on. Switch off FROSTMATIC or COOLMATIC manually, or wait until the function resets automatically to set the temperature. Refer to "FROSTMATIC or COOLMATIC function". DEMO appears on the display. The appliance is in demon- Keep the OK pressed for ap- stration mode. proximately 10 seconds until a long sound is heard and dis- play shuts off for a short time. The temperature in the ap- The temperature regulator Set a higher/lower tempera- pliance is too low/too high. is not set correctly. ture. The food products' temperature is too high. Let the food products temperature decrease to room temperature before storage. The door has been opened often. Open the door only if necessary. The FROSTMATIC function Refer to "FROSTMATIC func- is switched on. tion". There is no cold air circula- Make sure that there is cold air tion in the appliance. circulation in the appliance. If the advice does not lead to the desired result, contact the nearest Authorised Service Centre. 7.2 Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre.