AEG AGN71800C0 Product Manual - Page 4
Safety Instructions
View all AEG AGN71800C0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
4 www.aeg.com • Do not use water spray and steam to clean the appliance. • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. • Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. 2. SAFETY INSTRUCTIONS 2.1 Installation WARNING! Only a qualified person must install this appliance. • Remove all the packaging. • Do not install or use a damaged appliance. • Obey the installation instruction supplied with the appliance. • Always be careful when you move the appliance because it is heavy. Always wear safety gloves. • Make sure the air can circulate around the appliance. • Wait at least 4 hours before connecting the appliance to the power supply. This is to allow the oil to flow back in the compressor. • Do not install the appliance close to radiators or cookers, oven or hobs. • The rear of the appliance must stand against the wall. • Do not install the appliance where there is direct sunlight. • Do not install this appliance in areas that are too humid or too colds, such as the construction appendices, garages or wine cellars. • When you move the appliance, lift it by the front edge to avoid scratching the floor. 2.2 Electrical connection WARNING! Risk of fire and electrical shock. • The appliance must be earthed. • Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact an electrician. • Always use a correctly installed shockproof socket. • Do not use multi-plug adapters and extension cables. • Make sure not to cause damage to the electrical components (e.g. mains plug, mains cable, compressor). Contact the Authorised Service Centre or an electrician to change the electrical components. • The mains cable must stay below the level of the mains plug. • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. 2.3 Use WARNING! Risk of injury, burns, electrical shock or fire.