AEG BE3003001M Product Manual - Page 26

26 What to do if... Removing and cleaning the door glass panels 1. Remove the door. 2. Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal. 3. Pull the door trim to the front to remove it. B 4. Hold the door glass panels on their top edge one by one and pull them up out of the guide 5. Clean the door glass panels. To install panels follow the procedure in reverse. Install the smaller panel first, then the larger. WHAT TO DO IF... WARNING! Refer to "Safety information" chapter. Problem Possible cause Remedy The oven does not heat up The oven is not switched on Switch on the oven The oven does not heat up The clock is not set Set the clock The oven does not heat up The necessary settings are not Control the settings set The oven does not heat up The fuse in the fuse box is released Control the fuse. If the fuse is released more than one time, refer to a qualified electrician. The oven lamp does not oper- The oven lamp is defective ate Replace the oven lamp Steam and condensation settle You left the dish in the oven on the food and in the oven for too long cavity Do not leave the dishes in the oven for longer than 15 - 20 minutes after the cooking process ends The display shows "12.00" A power cut Reset the clock If you cannot find a solution to the problem yourself, contact your dealer or the service centre.