AEG L7WEG841R User Manual - Page 10
Water-stop device, Water drainage
View all AEG L7WEG841R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 www.aeg.com 2. Position it toward left or right depending on the position of the water tap. 45O 20O Make sure that the inlet hose is not in vertical position. 3. If necessary, loose the ring nut to set it in the correct position. 4. Connect the water inlet hose to the cold water tap with 3/4" thread. A If this occurs, close the water tap and contact the authorized service centre to replace the hose. 3.6 Water drainage The drain hose should be positioned at a height of not less than 60 cm and not more than 100 cm from the floor. You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. It is possible to connect the drain hose in different ways: 1. Make a U shape with the drain hose and put it around the plastic hose guide. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replacement of the inlet hose. 3.5 Water-stop device The inlet hose has a water stop device. This device prevents water leaks in the hose because of its natural ageing. The red sector in the window «A» shows this fault. 2. On the edge of a sink - Fasten the guide to the water tap or to the wall. Make sure that the plastic guide cannot move when the appliance drains.