AEG L7WEG841R User Manual - Page 38

38 www.aeg.com • - The mains supply is unstable. Wait until the mains supply is stable. • - No communication between electronic elements of the appliance. Switch it off and switch on again. 16.2 Possible failures The programme was not finished properly or the appliance stopped too early. If the alarm code appears again, contact the Authorised Service Centre. • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre. WARNING! Deactivate the appliance before carrying out any check. Problem Possible solution The programme does not start. • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed. • Make sure that there is no damaged fuse in the fuse box. • Make sure that the Start/Pause has been touched. • If the delay start is set, cancel the setting or wait for the end of countdown. • Deactivate the Child Lock function if it is on. • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. • Make sure that the water tap is not clogged. The appliance does not • Make sure that the inlet hose has no kinks, damages or fill with water properly. bends. • Make sure that the connection of the water inlet hose is correct. • Make sure that the filter of the inlet hose and the filter of the valve are not clogged. Refer to 'Care and cleaning'. The appliance fills with • Make sure that the drain hose is in the correct position. The water and drains immedi- hose may be positioned too low. Refer to "Installation in- ately struction".