AEG L88409FL2 Product Manual - Page 26

26 www.aeg.com Problem Possible cause The appliance The water drain hose is does not drain the damaged. water. The filter of the drain pump is blocked. The appliance door is open or not closed correctly. The anti-flood device is on. The connection of the water drain hose is not correct. A washing programme without the drain phase is set. The function Rinse & Hold is on. The spin phase does not operate. The spin phase is off. The filter of the drain pump is blocked. Balance problems with the laundry load. The programme does not start. The mains plug is not connected in the mains socket. Blow out fuse in the household fuse box. You did not press button 4 . The delay start is set. There is water on the floor. The Child Lock function is activated. Leakages from the couplings of the water hoses. Possible solution Make sure that the water drain hose has no damages. Clean the filter of the drain pump. Refer to 'Care and cleaning'. Make sure that the connection is correct. Set the drain programme. Set the drain programme. Close the door correctly. • Disconnect the appliance. • Close the water tap. • Contact the service centre. Set the spin programme. Clean the filter of the drain pump. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. Put in the mains plug. Replace the fuse. Press button 4 . To start immediately the programme, cancel the delay start. Deactivate the Child Lock function. Make sure that the couplings are tight.