AEG L88409FL2 Product Manual - Page 27

ENGLISH 27 Problem Possible cause Possible solution Leakages from the drain Make sure that the drain pump pump. filter is tight. The water drain hose is Make sure that the water inlet damaged. hose has no damages. You cannot open The washing pro- Let the washing programme the appliance gramme is in operation. end. door. There is water in the drum. Set the drain or the spin programme. The appliance Incorrect level of the ap- Adjust the level of the appli- makes an unusual pliance. ance. Refer to 'Installation'. noise. You did not remove the Remove the packaging and/or packaging and/or the the transit bolts. Refer to 'Instal- transit bolts. lation'. The load is very small. Add more laundry in the drum. The appliance fills The end of the drain with water and hose is too low. drain immediately. Make sure that the drain hose is in the correct position. The cycle is short- The appliance calculates See the 'Consumption Values' er than the time a new time according to chapter. displayed. the laundry load. The cycle is longer An unbalanced laundry This is a normal behaviour of than the time dis- load increases the dura- the appliance. played. tion time. The washing re- The detergent you used Increase the detergent quantity sults are not satis- was not sufficient or cor- or use a different one. factory. rect. You did not remove the Use special products to remove stubborn stains before the stubborn stains. you wash the laundry. Incorrect temperature Make sure that you set the cor- was set. rect temperature. Too much laundry load. Decrease the laundry load. The drum is empty and the display shows there is some weight in (J). It is necessary to set a tare. Press button 1 to deactivate the appliance and to activate it again. The drum is full but the display shows 0.0 kg (J). You loaded the laundry before to activate the appliance. Press button 1 to deactivate the appliance. Empty the drum and obey to the necessary steps. (Refer to 'Loading the laundry')