AEG T65170AV Product Manual - Page 23

that the steam exhaust is unobstructed. Thus, if a permanent hose installed to an external wall or ceiling, it must be ensured an exhaust capacity of mini- mum 150 m3/h. If the dryer is installed adjacent to kitchen units, make sure that the vent hose is not squashed. If the hose is not fully squashed, drying efficiency will be decreased , resulting in longer drying times and higher ener- gy consumption. If the hose is fully squashed, the automatic cut-outs with A which the appliance is fitted can oper- ate. When operating the tumble dryer, the room temperature must not be low- er than +5°C and higher than +35°C, as it can affect the performance of the ap- pliance. THE LOAD DOOR REVERSAL A WARNING! Before changing the door stop, disconnect the mains plug. ENGLISH 23 B C B 1. Open load door. 2. Unscrew hinge A from the front of the appliance and remove the load door. 3. Remove cover plates B. To do this, put a thin screwdriver into the slots as shown in the illustration, push down lightly and remove the cover plates. 4. Use an applicable tool and apply pressure to unlock part C, remove and turn it through 180°, then put on the other side. CAUTION! There is a small spring below locking block C. To put all parts together correctly, look at the illustrations: