AEG T65170AV Product Manual - Page 24

24 12. Put load door and hinges into recesses on the front of the appliance and screw down. Note regarding contact protection: The appliance is only secure for operations again once all plastic parts have been put. 5. Unscrew hinge A from the load door and turn it through 180°, then put on the opposite side and screw down. 6. Turn cover plates B through 180° and put them on the opposite side. 7. Unscrew cover plates D from the front of the appliance, turn through 180° and screw down on the opposite side. D E E D F F 8. Unscrew door lock E, push down lightly and remove from the front of the appliance. 9. Push snap-in button F in and down, push cover down lightly and remove from front of the appliance. 10. Change door lock E above to the opposite side, screw down the door interlock. 11. On the other side, put cover F and let snap-in button to lock into position. ELECTRICAL CONNECTION • Connect the appliance to a grounded socket. Refer to the applicable electrical requirements. • Make sure that the electrical data on the rating plate agrees with the power supply. • Always use a correctly installed shockproof socket. • Do not use multiple plugs and extension cables. There is a risk of fire. • All replacements of power supply cable must be carried out by our Service. • Make sure not to squash or cause damage to the mains plug and cable behind the appliance. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • The plug must be dry. The data about mains voltage, type of current and the necessary fuse are on the rating plate and in the "TECHNICAL INFORMATION" chapter. The rating plate is behind the load door (see the "PRODUCT DESCRIPTION" chapter). The appliance has a power supply cable with plug fitted with 13 A fuse. If necessary, replace the fuse in the plug by 13 A ASTA BS 1363/A approved fuse. The wires in the power supply cable are coloured as follow: