ASRock ALiveSATA2-GLAN User Manual - Page 35

Burst Length Burst length can be set to 8 or 4 beats. Bank Interleaving Interleaving allows memory accesses to be spread out over banks on the same node, or accross nodes, decreasing access contention. Memory Hole Use this to enable or disable memory hole. The default value is [Disabled]. DDRII Initialization Mode Configuration options: [Auto] and [Compatible]. The default value is [Auto]. AddrCmdFineDelay Offset This item is set to [Auto] by default. You may adjust the value of Address/ Command Fine Delay for memory. Configuration options: [Auto], [0], [5]. 3.3.2 Chipset Configuration BIOS SETUP UTILITY Advanced Chipset Settings DRAM Voltage Primary Graphics Adapter V-Link Speed PCI Delay Transaction IDE Drive Strength OnBoard LAN [Auto] [PCI] [Normal] [Disabled] [Normal] [Enabled] OnBoard HD Audio Front Panel Control [Auto] [Auto] HT Link Speed HT Link Width [Auto] [Auto] To set DRAM Voltage. +F1 F9 F10 ESC Select Screen Select Item Change Option General Help Load Defaults Save and Exit Exit v02.54 (C) Copyright 1985-2003, American Megatrends, Inc. DRAM Voltage Use this to select DRAM voltage. Configuration options are [Auto], [Low], [Normal], [High], and [Ultra High]. The default value is [Auto]. Primary Graphics Adapter This item will switch the PCI Bus scanning order while searching for video card. It allows you to select the type of Primary VGA in case of multiple video controllers. V-Link Speed Use this to select the speed of V-Link Bus. Configuration options are [Normal], [Fast]. The default value is [Normal]. PCI Delay Transaction Enable PCI Delay Transaction feature will free the PCI Bus when the CPU is accessing 8-bit ISA cards. Disable this feature when using ISA cards that are not PCI 2.1 compliant. 35