ASRock K8SLI-eSATA2 Quick Installation Guide - Page 18
K8sli-esata2
View all ASRock K8SLI-eSATA2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Primary IDE Connector (Blue) Secondary IDE Connector (Black) (39-pin IDE1, see p.2 No. 8) (39-pin IDE2, see p.2 No. 7) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: If you use only one IDE device on this motherboard, please set the IDE device as "Master". Please refer to the instruction of your IDE device vendor for the details. Besides, to optimize compatibility and performance, please connect your hard disk drive to the primary IDE connector (IDE1, blue) and CD-ROM to the secondary IDE connector (IDE2, black). Serial ATA II Connectors (SATAII_BLUE: see p.2, No. 14) (SATAII_BLACK: see p.2, No. 13) (SATAII_RED: see p.2, No. 10) (SATAII_ORANGE: see p.2, No. 11) SATAII_RED These four Serial ATA II (SATAII) connectors support SATAII_ORANGE SATA data cables for internal storage devices. The current SATAII_BLACK SATAII_BLUE SATA II interface allows up to 3.0 Gb/s data transfer rate. SATAII_RED and SATAII_ORANGE connectors can be used for internal storage devices or be connected to eSATAII_BOTTOM and eSATAII_TOP connectors with corresponding color to support eSATAII devices. Please read "eSATAII Interface Introduction" on page 22 for details about eSATAII and eSATAII installation procedures. eSATA II Connectors (eSATAII_TOP: see p.2, No. 37) (eSATAII_BOTTOM: see p.2, No. 38) eSATAII_TOP eSATAII_BOTTOM These two eSATA II connectors support SATA data cables for external SATAII function. The current eSATA II interface allows up to 3.0 Gb/s data transfer rate. Serial ATA (SATA) Data Cable 18 Either end of the SATA data cable can be connected to the SATA / SATAII hard disk or the SATAII connector on the motherboard. You can also use the SATA data cable to connect SATAII connectors and eSATAII connectors with corresponding color. ASRock K8SLI-eSATA2 Motherboard English