Aastra DT433 User Guide - Cordless Phones for MX-ONE - Page 46
Alarm with Location Information, Acoustic Location Signal, Automatic Call after Alarm
View all Aastra DT433 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
User Manual Cordless Phones for MX-ONE™ No-movement alarm: If no movement is detected during a preset time (default 30 seconds), the No-movement alarm will be triggered. When an alarm is triggered, the following occurs; • A Man-down warning. Cancel? or No- movement warning. Cancel? dialog window is shown in the display, and a warning tone is also signaling during a period (default 7 seconds) before the alarm is sent. • To prevent the alarm from being sent and silencing the warning tone, do one of the following: - Press any key/button. The alarm will be reset. - Put the handset in a charger. The alarm will be temporarily disabled indicated by that the corresponding alarm icon is hidden. The alarm will be enabled when removing it from the charger. • If no key/button is pressed during the warning tone, the alarm is sent. Depending on set parameters, a beep/vibrator/LED signal confirms that the alarm has been sent. • An acoustic location signal (ALS) may be activated after the alarm has been sent, or a call may be established to a predefined number. See 12.4 Acoustic Location signal and 12.6 Automatic Call after Alarm. • Information about the handset's location may be sent along with the alarm, see 12.3 Alarm with Location Information on page 40. See also 13.8.10 Alarm Settings on page 63. 12.3 Alarm with Location Information Information about the handset's location can be sent along with an alarm. The location can be added as follows; • An approximately location given by the closest Base Station (see the handset's Configuration Manual) or, Note: This function requires CPDM3 12.3.1 Alarm with Data The data must manually be defined and stored by the user, see Edit Alarm Data on page 62. It is recommended to add a shortcut for quick access to the "Edit alarm data" menu, see 13.7 Shortcuts on page 55. 12.4 Acoustic Location Signal Depending on set parameters, the ramped up ALS is played after an alarm. The signal is always ramped from the lowest volume to the highest. Press to turn the ALS off. Depending on the PDM settings, it is possible to make the user enter a password when turning the ALS off. The password is the same as the phone lock password. ALS is configurable for Man-down & No-movement alarm, and Push-button alarm. See the handset's Configuration Manual for more information. 12.5 Automatic Call after Alarm A handset can be setup to call a pre-defined number after an alarm has been sent. It is also possible to dial the number without sending an alarm by pressing a push-button that is not 1424-EN/LZT 103 089 B 2014-04-13 40