Acer AB2x280 F1 Acer AB7000 Enclosure with AB2x280 F1 and AB460 F1 Blade Serve - Page 41

Switch module removal and installation Removing a Switch Module 1. Pull out the release handle to the open position (1) and push in the direction indicated ( 2) and pull the module out of the bay (3). . 2. Replace immediately with another module or with a dummy module cover to maintain airflow integrity. Installing a Switch Module 1. Make sure the cover to the module has been installed before proceeding. 2. Remove the dummy cover from the bay you want to place the module in. 3. Place the module's release handle in the open position. 4. Slide the module into the module bay until it stops. 5. Push the release handle to the closed position. NOTE: After the module has been installed and the handle locked, it will turn on and a POST test will run to verify it is working properly. If there are no problems the blue Init. OK LED on the module will illuminate and you will see an OK under INITIATED in the GBE SWITCH screen of the management software utility. NOTE: If the module is installed in a top bay it must be positioned upside-down. Hardware removal and installation 33