Acer AB2x280 F1 Acer AB7000 Enclosure with AB2x280 F1 and AB460 F1 Blade Serve - Page 65

Chapter 8 BIOS Setup This chapter describes the BIOS Setup Utility for your server. The AMI ROM BIOS is stored in a Flash EEPROM and can be easily updated. To enter the BIOS Setup Utility, press the key while the system is booting up. Each main BIOS menu option is described in this manual. The Main BIOS setup menu screen has two main frames. The left frame displays all the options that can be configured. Grayed-out options cannot be configured. Options in blue can be configured by you. The right frame displays the key legend. Above the key legend is an area reserved for a text message. When an option is selected in the left frame, it is highlighted in white. Often a text message will accompany it. NOTE: The BIOS has default text messages built in. Acer retains the option to include, omit or change any of these text messages. The BIOS setup utility uses a key-based navigation system called hotkeys. Most of the BIOS setup utility hotkeys can be used at any time during the setup navigation process. These keys include , , , and arrow keys. Changing configuration data The configuration data that determines the system parameters may be changed by entering the BIOS setup utility. This setup utility can be accessed by pressing at the appropriate time during system boot. Starting the setup utility normally, the only visible Power-On Self-Test (POST) routine is the memory test. As the memory is being tested, press the key to enter the BIOS setup utility main menu. From the main menu, you can access the other setup screens. A BIOS identification string is displayed at the left bottom corner of the screen below the copyright message. WARNING:Do not upgrade the BIOS unless your system has a BIOS-related issue. Flashing the wrong BIOS can cause irreparable damage to the system. In no event shall Acer be liable for direct, indirect, special, incidental, or consequential damages arising from a BIOS update. If you have to update the BIOS, do not shut down or reset the system while the BIOS is updating. This is to avoid possible boot failure. Chapter 8 57