Acer Altos G300 Acer Altos G300 User's Guide - Page 98
Appendix A: AMIBIOS POST Checkpoint Codes, Displaying the Hit
![]() |
View all Acer Altos G300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
86 Appendix A: AMIBIOS POST Checkpoint Codes Checkpoint Code Description 37h The display mode is set. Displaying the power on message next. 38h Initializing the bus input, IPL, general devices next, if present. See page 91 for additional information. 39h Displaying bus initialization error messages. See page 91 for additional information. 3Ah The new cursor position has been read and saved. Displaying the Hit message next. 3Bh The Hit message is displayed. The protected mode memory test is about to start. 40h Preparing the descriptor tables next. 42h The descriptor tables are prepared. Entering protected mode for the memory test next. 43h Entered protected mode. Enabling interrupts for diagnostics mode next. 44h Interrupts enabled if the diagnostics switch is on. Initializing data to check memory wraparound at 0:0 next. 45h Data initialized. Checking for memory wraparound at 0:0 and finding the total system memory size next. 46h The memory wraparound test is done. Memory size calculation has been done. Writing patterns to test memory next. 47h The memory pattern has been written to extended memory. Writing patterns to the base 640 KB memory next. 48h Patterns written in base memory. Determining the amount of memory below 1 MB next. 49h The amount of memory below 1 MB has been found and verified. Determining the amount of memory above 1 MB memory next.
![](/manual_guide/products/acer-computers-altos-g300-acer-altos-g300-users-guide-55bfec3/98.png)