Acer Altos R710 Altos R710 Service Guide - Page 83
Installing and Removing a Hard Disk Drive
View all Acer Altos R710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Installing and Removing a Hard Disk Drive Up to five hot-swaps SCSI drives can be installed into your chassis. The number of drives and the drive type allowed depend on the Altos R710 Server system and the add-in components that you are installing. Installing a Hot-swap Hard Disk Drive 1. Remove the front bezel if it is installed. 2. Press in on the green latch on the front of the hard drive carrier. 3. Pull out on the black lever to slide the carrier from the chassis. 4. Remove the four screws that attach the plastic retention device or the previously installed hard drive to the drive carrier. Two screws are at each side of the retention device or the hard drive. Store the plastic retention device for future use. 5. Remove the hard drive from its wrapper and place it on an antistatic surface. 6. Set any jumpers and/or switches on the drive according to the drive manufacturer's instructions. 7. With the drive circuit-side down, position the connector end of the drive so that it is facing the rear of the drive carrier. Chapter 3 74