Acer Altos R710 Altos R710 Service Guide - Page 85

Installing or Removing a Floppy, CD-ROM, or DVD-ROM Drive CAUTION: Floppy, CD-ROM, and DVD-ROM drives are NOT hot swappable. Before removing or replacing the drive, you must first take the server out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the AC power cord from the system or wall outlet or disconnect the DC mains. Install a Slimline Floppy Drive into Altos R710 1. Power down the server system and unplug all peripheral devices and the AC power cable. 2. Remove the chassis cover. 3. Remove the front bezel. 4. Align the two holes at the left side of the floppy drive with the two cutouts in the floppy drive carrier. See letter "A" in the figure below. 5. Lower the right side of the floppy drive into the carrier until it clicks into place. A B TP01082 6. Open the connector on the rear of the floppy drive by pulling up on the connector cover. See letter "A" in the figure below. 7. Insert one end of the 26-pin floppy drive data cable end into the connector. 8. Push down on the connector cover to lock the cable into place. Chapter 3 76