Adaptec ACS 100 User Guide - Page 8
Installing a Disk Drive - usb
![]() |
UPC - 760884148273
View all Adaptec ACS 100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installing a Disk Drive Before you begin, ensure that you are installing the proper disk drive. The Adaptec ACS-100 USB Enclosure supports 3.5-inch IDE hard disk drives only. Note: You need a Phillips screwdriver to complete this task. To install a disk drive into your USB Enclosure: 1 Use a screwdriver to remove the two screws on the back of the enclosure. 2 Remove the enclosure's back panel, as shown below, and slide out the disk drive tray. 3 Connect the disk drive tray's internal power connector and IDE cable to the disk drive. 7
![](/manual_guide/products/adaptec-acs-100-user-guide-acafa58/8.png)
7
Installing a Disk Drive
Before you begin, ensure that you are installing the proper disk
drive. The Adaptec ACS-100 USB Enclosure supports 3.5-inch IDE
hard disk drives only.
Note:
You need a Phillips screwdriver to complete this task.
To install a disk drive into your USB Enclosure:
1
Use a screwdriver to remove the two screws on the back of the
enclosure.
2
Remove the enclosure’s back panel, as shown below, and slide
out the disk drive tray.
3
Connect the disk drive tray’s internal power connector and IDE
cable to the disk drive.