Contents
vi
OmniSwitch 6400 Series Hardware Users Guide
April 2011
OmniSwitch 6400 Series Stack Overview
......................................................................
5-3
Roles Within the Stack
....................................................................................................
5-3
Primary and Secondary Management Modules
.......................................................
5-3
Primary Management Module Selection
...........................................................
5-6
Secondary Management Module Selection
.......................................................
5-9
Idle Module Role
....................................................................................................
5-11
Pass-Through Mode
...............................................................................................
5-12
Recovering from Pass-Through Mode (Duplicate Slot Numbers)
..................
5-13
Stack Redundancy and Failover
....................................................................................
5-16
Checking Redundant Stacking Cable Status
..........................................................
5-17
Slot Numbering
.............................................................................................................
5-18
Dynamic Slot Number Assignment
........................................................................
5-19
Manual Slot Number Assignment
..........................................................................
5-21
Reverting to the Dynamic Slot Numbering Model
..........................................
5-22
Hot-Swapping Modules In a Stack
...............................................................................
5-23
Removing Switches from an Existing Stack
..........................................................
5-23
Inserting Switches Into an Existing Stack
..............................................................
5-23
Merging Stacks
.......................................................................................................
5-24
Reloading Switches
.......................................................................................................
5-25
Reloading the Primary Management Module
........................................................
5-25
Reloading the Secondary Management Module
....................................................
5-27
Reloading Switches with Idle Roles
.......................................................................
5-29
Reloading Switches in Pass-Through Mode
..........................................................
5-29
Reloading All Switches in a Stack
.........................................................................
5-30
Software Synchronization During a Full Reload
.............................................
5-30
Effects of Saved Slot Number Information on the Reload Process
.................
5-30
Avoiding Split Stacks
.............................................................................................
5-32
Changing the Secondary Module to Primary
................................................................
5-33
Synchronizing Switches in a Stack
...............................................................................
5-35
Automatic Synchronization During a Full Reload
.................................................
5-35
Monitoring the Stack
.....................................................................................................
5-36
Visually Monitoring the Stack
...............................................................................
5-36
CLI Commands Supported on Both Primary and Secondary
Management Modules
............................................................................................
5-37
Chapter 6
Booting OmniSwitch 6400 Series Switches
.........................................................
6-1
Booting a Stand-Alone Switch
........................................................................................
6-1
Booting Stacked Configurations
.....................................................................................
6-2
Monitoring the Chassis
...................................................................................................
6-3
Checking the Overall Chassis Status
........................................................................
6-3
Checking the Temperature Status
............................................................................
6-3
Checking the Fan Status
...........................................................................................
6-4
Checking the Power Supply Status
..........................................................................
6-4
Additional Monitoring Commands
..........................................................................
6-4
Using LEDs to Visually Monitor the Chassis
..........................................................
6-4