Alcatel OS6400-24 User Guide - Page 69
Installing Power Supplies, Connecting a Power Supply to the Chassis, Anti-Static Warning., Note.
View all Alcatel OS6400-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Mounting OS6400 Switches Installing Power Supplies Installing Power Supplies OmniSwitch 6400 Series power supply can be installed in the following ways: • As a primary or backup supply directly connected to the back of an OmniSwitch 6400 Series chassis. See "Connecting a Power Supply to the Chassis" below for more information. • As a primary or backup supply rack mounted directly above or below the switch and connected with a cable. See "Connecting Chassis to Power Source" on page 3-19 for more information. DC power supplies require additional installation steps. See "DC Power Specifications" on page 2-32 for more information. Anti-Static Warning. Before handling any components, free yourself of static by wearing a grounding strap, or by grounding yourself properly. Static discharge can damage the switch and the backup power supply. Connecting a Power Supply to the Chassis Follow the steps below to connect a power supply directly (i.e., without a cable) to the rear of an OmniSwitch 6400 Series chassis. Note. For information on rack mounting power supplies and connecting the power supply via a connector cable, refer to "Rack Mounting Power Supplies" on page 3-15. 1 Place the chassis, power supply, and shelf on a smooth, clean, and dry surface. 2 Carefully slide the power shelf so that it is flush against the back of the chassis. 3 Tighten the two captive screws located on the left and right sides of the power shelf. OmniSwitch 6400 Series Hardware Users Guide April 2011 page 3-13