Alpine 9825 Owners Manual - Page 37
Installation - cda head unit
UPC - 793276711052
View all Alpine 9825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Installation Caution Do not block the unit's fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire. Air ventilation hole Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the CDA-9827/CDA-9825. Connect all other leads of the CDA-9827/CDA-9825 according to details described in the CONNECTlONS section. 3 1 No Pressure Here Mounting Sleeve (Included) Dashboard No Pressure Here This unit Remove the Detachable Front Panel (refer to page 5). Slide mounting sleeve from main unit. (see "Removal" on this page). Slide the mounting sleeve into the dashboard. NOTE Please examine the installation. Make certain that no external pressure is applied to either the top of the unit or the removable nosepiece. 2 Hex Nut (M5) Screw ∗∗ Bolt Stud Metal Mounting Strap ∗ Ground Lead Chassis This unit Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis. NOTE ** For the screw marked , use an appropriate screw for the chosen mounting location. Lock Pin Slide the CDA-9827/CDA-9825 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel. Removal 1 Remove the DETACHABLE FRONT PANEL. 2 Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin. 3 Pull the unit out, keeping it unlocked as you do so. Face Plate This unit Ground Lead ∗ Screws (M5 × 8) (Included) Mounting Bracket NOTE Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis. 35-EN