Alpine HCE-C300R Owners Manual - Page 20

M Switch adhesive sheet N Cord clamp (Switch) O Buzzer X3 P Mounting (Buzzer) Q Buzzer extension cable R Self-Tapping screw (3m) (Buzzer) (M6 × 10) S Buzzer adhesive sheet T Cord clamp (Buzzer) U Cord clamp (Camera extension cable) X3 V Waterproofing pad X5 W Waterproofing pad adhesive sheet X Calibration sheet (2039 × 100 mm) X2 Y Calibration sheet (1000 × 200 mm) 18-EN 2. Installing the Rearview camera 1 Determine a mounting location for the camera. When choosing the location, make sure that the camera and bracket won't come in contact with any part of the vehicle. Check the contact points after making the angle adjustments to the camera. The location should be flat to provide the self-adhesive on the base to make good surface contact. Also, ensure access to both of the angle-adjustment screws for proper tightening using the supplied hex wrench. e Recommended installation location See the following table to determine the attachment angle Install the camera so that this rounded part is clearly visible then viewed from the side of the vehicle. Camera height inch mm 51.2 1300 47.2 1200 43.3 1100 39.4 1000 35.4 900 31.5 800 27.6 700 23.6 600 19.7 500 17.7 450 Angle (degrees) (from horizontal plane) 40 - 59 38 - 57 35 - 55 33 - 52 30 - 49 27 - 46 24 - 42 21 - 38 18 - 33 16 - 30 • If the unit is not installed within the designated angle, calibration cannot be executed correctly. e Camera installation height Lowest: 430 mm (16.9") Highest: 1300 mm (51.2") e Largest left and right offset 400 mm (15.7") from the centre of the vehicle both in the left and right directions