Alpine IDAX001 Owners Manual - Page 8

Getting Started SOURCE/ ENT FUNC./SETUP Attaching 1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit. 2 Push the left side of the front panel until it locks firmly into the main unit. BACK Center Jog Dial VIEW Accessory List • Digital Media receiver 1 • Power cable 1 • Mounting sleeve 1 • Carrying case 1 • Front frame 1 • Bracket key 2 • Screw (M5x8 4 • USB cable 1 • iPod Dock interface cable 1 • Owner's Manual 1 set Turning Power On and Off Press SOURCE/ to turn on the unit. • The unit can be turned on by pressing any other button except (Release) and VIEW. The unit is also automatically turned on if an iPod (USB connection) or USB memory is connected. Press and hold SOURCE/ for at least 2 seconds to turn off the unit. Detaching and Attaching the Front Panel Detaching 1 Turn off the unit power. 2 Press (Release) at the lower left side until the front panel pops out. 3 Grasp the left side of the front panel and pull it out. • Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit. • Attach the front panel carefully. Hold the panel by its sides to avoid pushing any buttons by mistake. Initial System Start-Up Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc. 1 Turn off the unit power. 2 Press (Release) to remove the front panel. 3 Press RESET with a ballpoint pen or similar pointed object. Adjusting Volume Turn the Center Jog Dial until the desired sound is obtained. • If the Center Jog Dial is repeatedly turned clockwise/counter- clockwise one step and held, the volume will increase/decrease incrementally, a step at a time. If the Center Jog Dial is turned two steps and held, the volume will change increase/decrease at a faster rate. • The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel.) This is not a malfunction. • To protect the front panel, place it in the supplied carrying case. 6-EN