Alpine IVA W200 Owners Manual - Page 34

GENERAL Setup General Setup Operation 5 Touch [RETURN] to return to the previous screen. Touch [CONTROL] to return to the main source screen that was displayed before the setup operation was started. • Immediately after changing the settings of General Mode (While the system is writing data automatically) do not turn the ignition key (engine key) to OFF. Otherwise, the settings may not be changed. To display the General mode screen: To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below. 1 Bring your vehicle to a complete stop at a safe location. Engage the parking brake. 2 Keep pushing the foot brake and release the parking brake once then engage it again. 3 When the parking brake is engaged for the second time, release the foot brake. • For automatic transmission vehicles, place the transmission lever in the Park position. Now, the locking system for the General mode operation has been released. Engaging the parking brake can reactivate the General mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3) of "To display the General mode screen." Each time the ignition is turned OFF, perform the procedure of "To display the General mode screen." Displaying the Time The clock indication on the monitor display is turned on or off respectively. Setting item: CLOCK Setting content: OFF / ON Setting the Time Setting item: CLOCK ADJUST Further setting items : HOUR / MINUTE / TIME ADJUST Setting content: 1-12 / 0-59 / RESET HOUR: MINUTE: RESET: Adjust the hour. Adjust the minute. If the clock shows less than 30 minutes past, the minute will be ": 0"; more than 30, the hour advances. • The clock-adjusting mode is canceled when the power is turned off, when [RETURN] or [CONTROL] is touched. The following steps 1 to 5 are common operations to each "Setting item" of GENERAL Setup. Refer to each section for details. 1 Touch [SETUP] on the main source screen. The SETUP selection screen is displayed. 2 Touch [OTHER SETUP]. The OTHER SETUP screen appears. 3 Touch [ ] of GENERAL SETUP. The GENERAL setup screen appears. 4 Touch [OFF], [ON] or [ ], [ ], etc., of the desired item to change its setting. Setting items: CLOCK / CLOCK ADJUST / DAYLIGHT SAVING TIME / DEMONSTRATION / BEEP / AUTO SCROLL / ADF* / PLAY MODE / LED DIMMER LEVEL * Displayed only when XM Satellite Radio Receiver is connected. Setting Daylight Saving Time Setting item: DAYLIGHT SAVING TIME Setting content: OFF / ON ON: Place the Summer Time mode ON. The time advances by one hour. OFF: Return to the ordinary time. Demonstration Function This unit is equipped with a demonstration function capable of showing basic operations of respective sources on the monitor display. Setting item: DEMONSTRATION Setting content: OFF / ON ON: Turns on the demonstration mode to show the basic operations. OFF: Turns off the demonstration mode. • The demonstration operation is automatically repeated until the function is turned off. Sound (Beep) Guide Function Setting item: BEEP Setting content: OFF / ON ON: Activate the Sound Guide mode. OFF: Deactivate the Sound Guide mode. The sound guide beep will not be produced when a button on the unit is pressed. 32-EN