Alpine KTX-100EQ Owners Manual - Page 6

7 When microphone placement is complete, get out of the vehicle, and close all doors, windows and sunroof. Then, start measurement by double-clicking the Measure button on the IMPRINT SOUND MANAGER screen. Do not open the doors until "Complete" is displayed on the screen and signal sound is output from the speakers and sound characteristics are measured in the vehicle. If noise enters from outside during measurement, "Error" will be displayed on the screen. If displayed, measure again by double-clicking the Measure button. • Perform PC operation outside the vehicle. • As measurement error may cause. never remove the microphone during measurement. 8 When the first measurement is complete, move the microphone to the next measurement location according to the indications on the screen and set it up. Repeat the procedure in step 7 according to the indications on the screen. Preforming measurement from two locatiolls in the car should be sufficient. If you want to finish after two measurement locations, double-clicking the Result button, alld move to the Target Curve settillg. For more precise measurement, 6 measurement locations are available; however, it will take approx. 40 minutes until all MultEQ measurements have been completed. III this case, be sure to perform MultEQ measurement with the vehicle collnected to a car battery charger. 9 When measurement is complete, double-clicking the Result button, and make the Target Curve setting for sound characteristics adjustment. Select the Target Curve Select button on the screen for the target curve setting. • The measurement data call/lOt be stored an the PC hard disc. but can be memorized in the CDA-9887/CDA9887R.