Alpine KTX-100EQ Owners Manual - Page 7

10 When the selection of Target curve is complete, double-clicking the Send Filter button to move to the setting of the CDA-9887/CDA-9887R. Select Curve Memory 1 or Curve Memory 2 to store in the CDA-9887/CDA-9887R. • You can store two curve settings for one measurement result. 11 If you are not satisfied with the measurement result, you can start from the procedure in step 7 by double-clicking the Re-Measure button. • If you pel/onn the measurement again using the Re-Measure button, note that the previously stored seltings in the CDA-9887/CDA-9887R will be cleared and replaced by the new one. 12 When the memory setting is complete, click x on the right side of the screen and double-clicking OK on the EXIT screen to close the IMPRINT SOUND MANAGER program. 13 After you have finished the MultEQ setting, disconnect the head unit connection cable from the CDA-9887/CDA-9887R, and then bring the front panel back to the original position. When you bring the front panel back to the original position. do /lot tum power off and on with the ignition key or battelY. 14 Enjoy the CDA-9887/CDA·9887R by turning on the MultEQ mode. For details on operation, refer to the Owner's Manual supplied with the CDA-9887/CDA-9887R. About Trademark • This device is manufactured under license from Audyssey Laboratories. U.S. and Foreign patents pending. Audyssey MultEQ XT is trademark of Audyssey Laboratories. • Microsoft and Windows are trademarks, or registered trademarks of Microsoft Corporation in the United States and/or other countries. 6-EN