Alpine N872A Installation Guide - Page 4
Precautions, IMPORTANT, Caution - navigation system
UPC - 793276100139
View all Alpine N872A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Caution Precautions ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED BY A SHARP METAL EDGE. Route the cables and wiring away from moving parts (like the seat rails) or sharp or pointed edges. This will prevent crimping and damage to the wiring. If wiring passes through a hole in metal, use a rubber grommet to prevent the wire's insulation from being cut by the metal edge of the hole. HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS. The wiring and installation of this unit requires special technical skill and experience. To ensure safety, always contact the dealer where you purchased this product to have the work done. USE SPECIFIED ACCESSORY PARTS AND INSTALL THEM SECURELY. Be sure to use only the specified accessory parts. Use of other than designated parts may damage this unit internally or may not securely install the unit in place. This may cause parts to become loose resulting in hazards or product failure. DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST. Avoid installing the unit in locations with high incidence of moisture or dust. Moisture or dust that penetrates into this unit may result in product failure. IMPORTANT Please record the serial number of your unit in the space provided on the back cover of Owner's Manual and keep it as a permanent record. The serial number plate is located on the bottom of the unit. • For installation of the main unit, avoid areas with a high incidence of dust or moisture. Installing the unit in such locations may result in contamination of the DVD ROM making it unreadable. • Do not install the navigation system near a CD player that may interfere with GPS signal reception. • The optimum locations for installing the GPS antenna are: - on the dashboard where no metal piece (such as the defogger wire or antenna wire) is located on the windshield. - where no metal cover is located. • Route the Speed Pulse Sensor cable away from the audio cables in order to avoid picking up noises. 3