Alpine S690 Owners Manual - Page 39
Preparation, Connecting, Mounting the Remote Control Sensor Unit - dha installation
UPC - 093276200625
View all Alpine S690 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Preparation 1 Park the vehicle in a flat, safe place. Apply the parking brake, then remove the ignition key. 2 Check the included parts and organize the tools and installation instructions. Ai-NET cable (5.5m) RCA Extension cable (Video signal) (5m) Power cable (5m) 6 Remove the ignition key and disconnect the battery's minus terminal. • Press the Reset button when using for the first time, etc., or change the car battery. 1 Hexagonal washer faced tapping screw (M5x15) 2 L-shaped bracket 3 Floor base 4 Shouldered hexagonal nuts (M6) 5 Hexagonal bolt (M6x25) 6 Double washer screw (M4x8) x 4 7 Shouldered hexagonal bolts (M6x50) x 2 x 2 x 8 x 4 Mounting strap Sheet of dust-prevention seals Protective plastic bag for shipping keys x 4 Disc magazine x 4 Infrared remote control unit (5.5m) Remote Control Battery (CR2025) x 1 Index seal sheet Reset • For details, refer to "Initial System Start-Up" (page 9). Mounting the Remote Control Sensor Unit • When using a monitor with a built-in remote control sensor, such as the IVA-D106, the external sensor is not used. • When mounting the unit with double-sided adhesive tape, make sure the mounting surface is dry and free from dirt or grease. 1 Press the double-sided adhesive tape onto the back of the remote control sensor unit. (Double-sided adhesive tape) 3 Disconnect the battery's minus terminal. Connecting 1 Connect as described on the basic connection diagram on page 40. • These instructions also include examples of connections with other products. (See pages 41 to 43.) • Check which combination of products you will be using and proceed accordingly. 2 Check that all connections are correct. 3 Connect the battery's minus terminal. 4 Turn ignition key on and power on the head unit, and switch a source to DVD changer or CD changer, then make sure sound will output correctly. • Before fixing, make sure the function works. If the function does not work correctly, check the connection again. 5 Turn off the DHA-S690's power. 2 Before completing the sensor mounting, make sure the location selected is within the operating range of the remote control. Peel off the backing of the adhesive tape and press the sensor onto the selected mounting location. Remote Control Sensor Unit 37-EN