Amana NTW4650YQ Use and Care - Page 12
detergent. Close lid and press START/Pause/Unlock Lid. - troubleshooting
View all Amana NTW4650YQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
TROUBLESHOOTING First try the solutions suggested here or visit our website at www.amana.com/help for assistance and to possibly avoid a service call. If you experience Possible Causes Washer not performing as expected (cont.) Washer won't run or fill, washer stops working or wash light remains on (indicating that the washer was unable to fill appropriately) (cont.) Check proper electrical supply. Normal washer operation. Washer may be tightly packed. Solution Plug power cord into a grounded 3 prong outlet. Do not use an extension cord. Ensure there is power to outlet. Reset a tripped circuit breaker. Replace any blown fuses. NOTE: If problems continue, contact an electrician. Lid must be closed for washer to run. Washer will pause during certain phases of cycle. Do not interrupt cycle. Washer spins the dry load for several minutes before filling to determine if load is balanced. You may hear the hum of the spins. This is normal. Remove several items, rearrange load evenly in basket, and add detergent. Close lid and press START/Pause/Unlock Lid. Add only 1 or 2 additional garments after washer has started. Washer not draining/ spinning, loads are still wet or spin light remains on (indicating that the washer was unable to pump out water within 10 minutes) Empty pockets and use garment bags for small items. Use a cycle with a low spin speed. The washer may be tightly packed or unbalanced. Small items may have been caught in pump or between basket and tub, which can slow draining. Cycles with lower spin speeds remove less water than cycles with high spin speeds. Use the recommended cycle/speed spin for your garment. To remove extra water in the load, select Drain/Spin. Load may need to be rearranged to allow even distribution of the load in the basket. Tightly packed or unbalanced loads may not allow the washer to spin correctly, leaving the load wetter than normal. Evenly arrange the wet load for balanced spinning. Select the Drain/Spin cycle to remove excess water. See "Using Your Washer" for loading recommendations. Check plumbing for correct Check drain hose for proper installation. Use drain hose form and securely drain hose installation. attach to drainpipe or tub. Do not tape over drain opening. Lower drain hose if Drain hose extends into the end is higher than 96" (2.4 m) above the floor. Remove any clogs from drain standpipe farther than hose. 4.5" (114 mm). Too much detergent Always measure and follow detergent directions for your load. To remove causing suds to slow or extra suds, select Rinse/Spin. Do not add detergent. stop draining and spinning. 12