Ariens Compact 22 Owners Manual - Page 27

6. Replace traction drive belt. 7. Swing drive plate toward friction disc and slide finger into stop hole in frame. 8. Reinstall swing gate spacer. NOTE: Make sure drive plate spring remains connected to the frame and drive plate. 9. Replace attachment drive belt (See Replace Attachment Drive Belt on page 25). ATTACHMENT CLUTCH/BRAKE ADJUSTMENT WARNING: IMPROPER ADJUSTMENT could result in unexpected movement of auger and impeller causing death or serious injury. AUGER / IMPELLER MUST STOP within 5 seconds when Attachment Clutch/Impeller Brake Lever is released. WARNING: Adjustment procedure requires the engine to be run with the belt cover off. AVOID INJURY. Read and understand the entire Safety section before proceeding. Remove Attachment Cable Slack 1. Loosen hardware securing belt cover to unit. NOTE: DO NOT completely remove the hardware from unit. 2. Remove belt cover. 3. Loosen jam nut on cable adjustment barrel, and then turn the adjustment barrel down to shorten cable and remove all cable slack (Figure 29). 1 2 3 1. Attachment Clutch Cable 2. Cable Adjustment Barrel 3. Jam Nut Figure 29 OS8255 4. With the attachment clutch disengaged, check that the attachment idler arm lightly touches the frame (Figure 29). 5. Tighten jam nut on cable adjustment barrel. GB - 27