Ariens Max Zoom 48 Operation Manual - Page 15
Pre-start, Stopping In An Emergency, Starting And Shut Off, To Mow With Unit
View all Ariens Max Zoom 48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Fuel Stabilizer Gasoline left in the fuel system for extended periods without a stabilizer will deteriorate, resulting in gum deposits in the system. These deposits can damage the carburetor and the fuel hoses, filter and tank. Prevent deposits from forming in the fuel system during storage by adding a quality fuel stabilizer to the fuel. Follow the recommended mix ratio found on the fuel stabilizer container. PRE-START CAUTION: Make sure all hardware is tight, all safety devices are in place and all adjustments are made correctly. 1. Check Safety Interlock System If this system does not function as described do not operate until repairs are made. 2. Check Air Cleaner Check air filter for dirt. Clean as required. Follow Engine Manual Maintenance Schedule. 3. Check Engine Fuel and Crankcase Oil Check and add fuel if required. Check that engine crankcase oil is full. Follow Engine Manual Maintenance Schedule. 4. Check Tire Pressure See Specifications on page 31 for correct tire pressure. 5. Check Hydraulic Fluid Level See Check Hydraulic Fluid Level on page 19. 6. Adjust Seat Be sure all controls can be reached safely from operator's position. 7. Set Cutting Height Make sure the deck is set to the correct cutting height. STOPPING IN AN EMERGENCY WARNING: Operating unit on slopes may lead to loss of steering control. When operating on slopes be prepared to react to an emergency situation. 1. Return steering levers to neutral position 2. Immediately set parking brake 3. Turn off PTO and engine STARTING AND SHUT OFF CAUTION: Read entire Owner/Operator Manual, Clutch Manual, and Engine Manual first. DO NOT attempt to start engine at this time. To start the engine: 1. Make sure the steering levers are in neutral. 2. Put the PTO switch in the "Off" position. 3. Engage parking brake. 4. If the engine is cold, move the choke control to the "On" position. If the engine is warm or hot, do not use choke. 5. Move the throttle to 3/4 "Fast" position. See Engine Manual for detailed instructions. 6. Put the ignition key in the switch and turn it to the "Start" position. 7. As soon as the engine starts, release the key. 8. Move the choke control to the "Off" position from the "Choke" position. Wait until the engine is running smoothly before operation. To stop the engine: 1. Bring the steering levers to neutral. Disengage the PTO and engage the parking brake. 2. Move the throttle lever to the "Slow" position. 3. Turn the ignition key to the "Off" position. TO MOW WITH UNIT Operate the unit only when seated in the operator's position. 1. Start the engine. Let the engine warm until it is running smoothly. 2. Release parking brake. GB - 15