Ariens Power Brush 28 Owners Manual - Page 8

ASSEMBLY WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. Tools Required: • Tire Gauge • 1/2-In. Wrench Unpacking Unit WARNING: Dropping or tipping over boxed unit could result in personal injury or damage to unit. Unfold Handlebar (Figure 3) 1. Remove the lower and loosen the upper hardware on the handlebar assembly. 2. Loosen the hardware on the shift rod. 3. Put the speed selector lever in the sixth forward position. 4. Rotate the handlebars into operating position. NOTE: Be careful not to damage cable spring hooks when rotating handlebars upward. 5. Install and tighten the hardware on the handlebar assembly and shift rod. . 2 1 3 4 1. Shift Rod 2. Upper and Lower Handlebar Hardware 3. Shift Rod Hardware 4. Handlebar Figure 3 OS8025 Check Tire Pressure CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly: • Do not attempt to mount a tire without the proper equipment and experience to perform the job. • Do not inflate the tires above the recommended pressure. • Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel. • Do not stand in front or over the tire assembly when inflating. Use a clip-on chuck and extension hose long enough to allow you to stand to one side. Check tire pressure and adjust to the pressure listed on tire sidewall. Check Engine Crankcase Oil IMPORTANT: Engine is shipped with 5W-30 oil in crankcase. Refer to Engine Manual for detailed instructions. Fill Engine Fuel Tank Refer to Engine Manual for proper type and capacity. Check Function of all Controls Ensure unit runs and performs properly. Refer to Operation. Run-in Attachment Belt 1. Start unit in a well-ventilated area according to Starting and Shut Off on page 13. 2. Engage attachment clutch lever and run attachment for about 15 minutes. 3. Stop unit, wait for all moving parts to stop, and remove spark plug wire. 4. Adjust belt finger, if necessary. See Attachment Drive Belt Replacement on page 19. 5. Adjust clutch idler according to Attachment Clutch/Brake Adjustment on page 21. GB - 8